Outdoor motion sensor light camera4/30/2024 To reset the modem, pull the plug out of the power cord, then turn it off. Check the locationĬheck for any obstruction blocking the motion sensors.Īn overgrown branch or leaves may be in the way of the camera.Īny dirt or gunk accumulated on the lens can also be the culprit of malfunctioning motion detection.Ĭlean the lens with a microfiber towel and clear up the area where your setup is located.Īnother possibility is the poor camera angle.Ĭonsider changing the camera's location. This will also affect the Blink Sync Module, causing motion detection to be faulty.Īs previously mentioned, the Floodlight only works with the Blink Outdoor camera, so don't attempt to pair it with your Blink Indoor or Blink XT. Otherwise, it means the strength of the internet connection is insufficient, which might cause some delays in connection. Make sure that there are always three bars for it to work properly. The Blink camera's signal strength can be checked in the camera settings. To ensure that the Wi-Fi network is linked correctly, bring the Floodlight closer to the sync module. Most smartphones, tablets, and Alexa-enabled products are supported by the Blink system. The latest version of the Blink app is always available in the app store. Insert the Floodlight mount's micro-USB cable into the Blink camera firmly to ensure a tight seal.Reattach the back cover on your outdoor camera once the USB port cover is fully removed.This will ensure a tight, weather-resistant seal between the Floodlight mount's micro-USB cable and the camera. Remove the back cover and the USB port covers from the outdoor camera completely.Now that we've listed down some of the most common reasons why a Blink Floodlight isn't turning on, here's a little troubleshooting guide you can try if you're experiencing the same issue. Top ways to fix the issue with your Blink Floodlight Check your firmware version by tapping the settings slider icon located at the top right corner of the outdoor camera. Your Blink Outdoor camera must have at least a 10.47 (or higher) firmware version installed to properly work with your Blink Floodlight. Make sure you have an Outdoor camera set up in your Blink account. Remember, the Blink Floodlight is only compatible with the Blink Outdoor camera. The micro-USB cable must be firmly attached to the Blink outdoor camera with a tight seal on all sides. The Floodlight's LED will 'blink' once if everything is installed correctly. Make sure the battery compartment is closed and the back cover is properly reattached after installing the batteries. Make sure you remove them after you remove the battery compartment. Pull tabs prevent the battery from having contact with the Blink Floodlight. The Blink Floodlight will only work correctly with your Blink Outdoor camera if you have the most current version of the Blink app. There are several possible reasons why this happens. So, why is your Blink Floodlight not turning on with motion? Reasons why your Blink Floodlight isn't turning on However, it's not as foolproof as you might think, and sometimes it fails to activate even when it detects motion. It aids Blink Outdoor cameras in poor visibility conditions by beaming 700 lumens of high-quality LED lights upon motion detection. You can always turn off the IR illuminator if you want colored night footage, but the quality will significantly decrease.Īs a solution, Blink introduced the Floodlight, which literally floods the darkness with light. One of the most obvious is night vision capabilities.Ĭompared to its rival brands that boast of fully colored night vision, the Blink camera system utilizes infrared night vision, capturing black and white images in low-light conditions. Of course, this modest price tag does not come without any trade-offs. The Blink Mini starts at just $34.99, while the Blink Outdoor Camera is priced at $99.99.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |